Question: Have read eeprom data from Peugeot Boxer 2014 SID208 ECU, but failed! Using Ktag
The Ktag can read the ECU year 2012, but cannot read 2014
Tech support from eobdtool.co.uk:
Here is a possible solution you can have a try.
That is, try with KTM bench programmer. SID208 is listed there.
If you have good luck, you might have a success!
The wiring is the same as Ktag.
Look here: SID208 ECU connected to the KTM bench
Important notes:
- the laptop cannot be connected to the Internet
- the programmer cannot be updated
Dollars are required for device repair if you do with network connection or update that leads to something wrong with your device.
KTM bench tech support: http://blog.eobdtool.co.uk/tag/ktm-bench/
- the wiring diagram is different, depending on the ECU type
pls select the menu in PCMfalsh to read or write ECU data
It’s not necessary to disassemble all 71 ECUs listed here.
Just connected by the BOOT cable
And GPT0 and GPT1 cables should be connected well
For example, the ECU EDC17C54 taken off the car
Then the ECU CPU should be TC1797
Just follow the wiring to connect the ECU
No need disassemble ECU!!!
DO NOT FORGET TO CONNECT GPT0 and GPT1 cables
In PCMfash software, choose 1798 CPU
Option [53] requires ECU disassembling and BOOT connection to read data.
Same as the way using cheap KTM flash cable or KTM flash 1.95 programmer
The steps:
First read password
Then read data
Disassemble ECUs or not?
That is a question.
Both have advantages and disadvantages.
- Easy and fast: you can read data for 5-10 minutes only, without disassembling an ECU.
usually, it will take more than 20 minutes to disassemble an ECU. it depends on personal technique and devices owned.
sometime, 1 hour is spent but the ECU has not been disassembled or even destroyed
- The original ECU is sealed. If it’s disassembled, then …
- Pls connect to the BOOT point with and ECU disassembled
- Pls seal the ECU after data is read out
On a side not,
No token limitation with KTM bench
Checksum is available when reading data
obdtoolshop 